Measurement
How to measure
1. Use a steel tape measure
2. Take your measurements in millimeters (mm)
3. Take the Width first, then the Drop
4. Take the exact measurement, do not round them up
5. Do not make any deductions or allowances Factory will make all necessary deductions on inside mounts. No deductions will be made on outside mounts
6. Check your measurements three times to avoid any errors before placing the order
7. Use the smallest measurement for your order
8. Take care to allow a generous overlap to prevent anyone being able to see in from outside.
9. Please take care to allow for any obstructions e.g. wall mounted light fittings etc.
10. Check your window or sliding door opening before making your selection.
INSIDE MOUNT (or Recess) Blind - The Blinds are to be installed on the inside of the window frame or window opening and covers the window opening exactly. Measure depth of recess to ensure that the blind has adequate room to operate-roll up and draw, allowing for any door or window handles. (ALLOW A CLEAR 50~70 mm)
OUTSIDE MOUNT (or Face Fix) Blind - The Blinds are to be installed outside the window frame (on the architrave) and covers an area lager than the window itself.
Installation
Installing a blind is easy. All you need is:
  • - A pencil
  • - Drill & bit
  • - screwdriver
Inside Mount Installation
Your blind will come with installation brackets and screws
1. With each blind you will receive two brackets - one male and one female
2. The male bracket is used for the chain control side of the blind.
3. The female bracket mounts on the pin (non-control) end.
4. Hold the brackets to the place on your window frame where they are to be fixed.
5. With a pencil mark the two screw holes for each bracket.
6. Drill a pilot hole in the middle of each marking with a drill bit.
7. Now use the screws provided to fix the brackets to the window frame.
8. Install your blind into the male bracket first which is also the chain end.
9. Hold the chain end in position and move to the other end of the blind.
10. Guide the metal spring loaded pin into the track of the female bracket until it clicks into position.
11. Your blind is now installed
Outside Mount Installation
1. With each blind you will receive two brackets - one male and one female
2. The male bracket is used for the chain control side of the blind.
3. The female bracket mounts on the pin (non-control) end.
4. Hold the brackets to the place on your window frame where they are to be fixed.
5. With a pencil mark the two screw holes for each bracket.
6. Drill a pilot hole in the middle of each marking with a drill bit.
7. Now use the screws provided to fix the brackets to the window frame.
8. Install your blind into the male bracket first which is also the chain end.
9. Hold the chain end in position and move to the other end of the blind.
10. Guide the metal spring loaded pin into the track of the female bracket until it clicks into position.
11. Your blind is now installed
To remove your blind
To remove the blind, turn the large wheel at the pin end anti clockwise.
This action will slide the metal pin inward and the blind will slide out of the bracket.
We Have Moved ~~~~

We moved to bigger place.

For Bigger service.

2 / 19 Aranda Street Slac...

Get Easy Quotation Now by free

Hello everyone.

You can get easy quotation using my website.

You can se...

Showroom OPEN !!!

Our New Showroom is open.

You can have a look some kinds of vertical blinds & r...

Vertical
Quotation
Material
Our product
Measure & Installation
Roller, Hollands
Quotation
Material
Our product
Measure & Installation
Wood & Timber Venetian
Material
Our product
Panel Glide, Roman
Material
Our product
Sunscreen, Dual Roller
Material
Our product
YSL Outlet
Shutter, Curtain & Awning
Material
Our product
Louboutin Outlet Online
Cheap Oakley Sunglasses